Pressure Systems 9022 Uživatelský manuál stáhnout pdf (Strana 161)

www.meas-

spec.com

Measurement Specialties Inc. NetScanner System (9016, 9021, & 9022) User’s Manual

6 - 4

NOTE: NetScanner

™

System modules are currently designed to use RARP

protocol

and BOOTP protocol for Dynamic IP address assignment.

When placed in Dynamic addressing mode, (through the TCP/IP

protocol ‘w1301’ command), the modules will first try to resolve

their addresses using RARP protocol. If no RARP server can be

found, the mo

dules will then use the BOOTP protocol. The modules

will alternate between these two protocols until a response is

received and an IP address is assigned. If you are not sure about

these protocols, or if your modules should be using them, please

contact your network administrator.

NOTE: A simple Windows

95/98/2000/XP/NT BOOTP/RARP server is

available free of charge from Measurement Specialties. For

additional information on the BOOTP Lite application, contact the

Sales or Applications Support Department at MEAS. The

application can also be downloaded from our website,

www.meas-spec.com

6.1.2.2 Host IP Address Assignment for Windows® 95/98/NT

In order to communicate with the Ethernet 9016, 9021, or 9022, the host computer must also be

configured with an appropriate IP address. For Windows® 95/98 and Windows® NT, a typical

configuration is described below. Note that this configuration assumes that a host PC Ethernet

adapter is installed and not in use for any other TCP/IP application. If your Ethernet adapter is

used for other TCP/IP communications, contact your MIS or network administrator to determine

proper host IP address and subnet mask configurations before proceeding.

Activate the Windows

control bar (left click the START icon). Select the SETTINGS line

followed by the CONTROL PANEL folder. In the CONTROL PANEL folder, select the

NETWORK icon. Once in the NETWORK setup, select the tab labeled CONFIGURATION.

Scroll through the list of installed configuration protocols. Select the one labeled

‘TCP/IP->xxxx’ where xxxx will typically identify your Ethernet adapter card. There may be

other TCP/IP protocols listed for other items such as dial up adapters, these are not used for the

NetScanner™ System Ethernet configuration. If the TCP/IP protocol is not listed in the

configuration menu, left click the ADD button. Continue by selecting to add a PROTOCOL.

Select MICROSOFT from the Manufacturers list. Then select TCP/IP from the networks

protocol list.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 193 194

Žádné komentáře

Pressure Systems 9022 Uživatelský manuál Strana 161